IBM L40 SX - Page 130

@D.2.3 For DOS 5.0 Users
@If you have installed Windows 3.0, do the following.
@1. At the DOS prompt (usually C:\>), type:
@ CD \
@ and press Enter.
@2. Type:
@ COPY CONFIG.SYS CONFIG.BAK
@ and press Enter.
@ This makes a backup copy of the CONFIG.SYS file.
@3. Find in the CONFIG.SYS file the two DEVICE command lines that specify
@ the filenames, HIMEM.SYS and SMARTDRV, for Windows 3.0. Using a
@ non-formatting text editor, change the DEVICE command lines to the
@ following.
@ DEVICE=C:\DOS\HIMEM.SYS
@ DEVICE=C:\DOS\SMARTDRV.SYS 512
@ HIMEM.SYS and SMARTDRV.SYS are the two drivers required to use this
@ disk cache program.
@4. Save and then exit from the file.
PS/2 Model L40 SX Quick Reference
For DOS 5.0 Users
¦ Copyright IBM Corp. 1991
D.2.3 - 1