@D.5.1 Installing the Power Management Device Driver for EMM386
@If you install an application that uses EMM386, do the following to
@install the power management device driver program for them.
$1. Insert the backup copy of the Reference Diskette into the diskette
$ drive.
$2. At the DOS prompt (usually C:\>), type A:UINSTALL and press Enter.
$ The following screen appears.
+-------------------------------------------------------------------------
¦
$ ¦ Installation Options
¦
$ ¦ ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
$ ¦ Installation Source Drive
$ ¦
$ ¦ Enter the installation SOURCE drive letter, the drive that the program
$ ¦ installs FROM:
$ ¦
$ ¦ Source Drive ... [ A ]
$ ¦
$ ¦ Enter F1=Help F3=Exit
$ ¦ ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
¦
$3. Press Enter twice.
$ The screen for selection appears.
$4. Using Down Arrow () or Up Arrow () select Install Additional DOS
$ Power Management (VCPI) Device Driver. Press Enter. Follow the
$ instructions on the screen.
$5. Remove the backup copy of the Reference Diskette from the diskette
$ drive.
PS/2 Model L40 SX Quick Reference
Installing the Power Management Device Driver for EMM386
¦ Copyright IBM Corp. 1991
D.5.1 - 1
To Next Page
Loading...
Need help?
General