IBM L40 SX - Page 142

To Next Page

To Previous Page

#E.1.1 Installing the SMARTDRV Driver

#+--- Assumption ---------------------------------------------------------+

¦ ¦

#¦ The following steps assume: ¦

¦ ¦

#¦  You have installed DOS 3.3 or 4.0. ¦

¦ ¦

#¦  You know how to copy files from the diskette drive to the hard ¦

#¦ disk drive. ¦

¦ ¦

+------------------------------------------------------------------------+

$1. Insert the backup copy of the Reference Diskette into the diskette

$ drive.

$2. At the DOS prompt (usually C:\>), type A:UINSTALL and press Enter.

$ The following screen appears.

+-------------------------------------------------------------------------

$ ¦ Installation Options

$ ¦ ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

$ ¦ Installation Source Drive

$ ¦

$ ¦ Enter the installation SOURCE drive letter, the drive that the program

$ ¦ installs FROM:

$ ¦

$ ¦ Source Drive ... [ A ]

$ ¦

$ ¦ Enter F1=Help F3=Exit

$ ¦ ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

$3. Press Enter twice.

$ The screen for selection appears.

$4. Using Down Arrow () or Up Arrow () select Install Disk Cache Driver.

$ Press Enter. Follow the instructions on the screen.

$5. Remove the backup copy of the Reference Diskette from the diskette

$ drive.

Subtopics

E.1.1.1 If You Have Any Problems

PS/2 Model L40 SX Quick Reference

Installing the SMARTDRV Driver

E.1.1 - 1

Other manuals for IBM L40 SX