IBM L40 SX - Page 167

#E.5.2 Installing the Parallel Connector Setup Program for OS/2
#To install this program, follow the steps below.
#Note: Make sure that the DOS compatibility box has been configured.
$1. Insert the backup copy of the Reference Diskette into the diskette
$ drive.
$2. At the prompt on the DOS compatibility box, type A:UINSTALL and press
$ Enter.
$ The following screen appears.
+-------------------------------------------------------------------------
¦
$ ¦ Installation Options
¦
$ ¦ ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
$ ¦ Installation Source Drive
$ ¦
$ ¦ Enter the installation SOURCE drive letter, the drive that the program
$ ¦ installs FROM:
$ ¦
$ ¦ Source Drive ... [ A ]
$ ¦
$ ¦ Enter F1=Help F3=Exit
$ ¦ ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
¦
$3. Press Enter twice.
$ The screen for selection appears.
$4. Using Down Arrow () or Up Arrow () select Install Parallel Connector
$ Setup Program for OS/2. Press Enter. Follow the instructions on the
$ screen.
$5. Remove the backup copy of the Reference Diskette from the diskette
$ drive.
PS/2 Model L40 SX Quick Reference
Installing the Parallel Connector Setup Program for OS/2
¦ Copyright IBM Corp. 1991
E.5.2 - 1