|3.1.1.1 Using the AC Adapter
|Warning: The AC Adapter is for use only with the Model L40 SX. Do not
|connect it to any other device. Do not use any ac adapter with the Model
|L40 SX, other than those authorized by IBM.
|The AC Adapter enables the Model L40 SX to operate under standard ac power
|at frequencies of 50 to 60 Hz and voltages of:
|Low range: 100-125 V ac (nominal)
|High range: 200-240 V ac (nominal)
|To use the AC Adapter, follow the instructions below.
|Plug the AC Adapter into the computer 1 . Plug the power cord into the
|AC Adapter 2 ; plug the other end into a properly grounded electrical
|outlet 3 .
|PICTURE 59
|Note: If the AC Adapter is connected, you can operate the computer even
@ with the Rechargeable Battery removed. However, do not remove the
@ Rechargeable Battery during suspend or partial suspend mode before
@ attaching the AC Adapter and plugging it into a working electrical
@ outlet.
PS/2 Model L40 SX Quick Reference
Using the AC Adapter
¦ Copyright IBM Corp. 1991
3.1.1.1 - 1
To Next Page
Loading...
Need help?
General