Power management features 3-3
APM
This feature allows the computer to save power through monitoring your computer’s
hardware. Follow these steps to use the APM feature:
1. Start the Configuration/Setup Utility (see “Configuration/Setup Utility
overview” on page 4-2.)
2. Select Power Management from the Configuration/Setup Utility menu
3. Select APM.
4. Set APM BIOS Mode to Enabled.
5. Select values for Power Management (time to low power, system power,
processor speed, etc.), as necessary.
6. Set IDE Drives to Enabled or disabled.
7. Press Esc to return to the Configuration/Setup Utility menu.
8. Before you exit from the program, select Save Settings from the
Configuration/Setup Utility menu.
9. To exit from the Configuration/Setup Utility menu, press Esc and follow the
instructions on the screen.
To Next Page
Loading...
