BIOS Setup configuration 4-9
Setup parameters
Devices and I/O Ports
Use the options in this menu to configure the devices and I/O ports in this computer.
Mouse
This setting allows you to select whether or not a mouse is installed.
Diskette Drive A
Use this setting to define the type of drive installed as drive A.
Serial Port Setup
Use these settings to define the I/O port address and interrupt-request number to be
used by the serial port.
Parallel Port Setup
Use these settings to define the I/O port address and interrupt-request number to be
used by the parallel port. These settings also control the parallel port mode (EPP,
ECP, ECP/EPP, or SPP, and the DMA setting for ECP, if used).
USB Setup
Use the settings for in this menu item to enable or disable the Universal Serial Bus
(USB) functions.
USB Support
Select enabled if you will be using USB devices.
None No floppy drive installed
720K, 3.5 in 3-1/2 inch double-sided drive; 720 kilobyte capacity
1.44M, 3.5 in 3-1/2 inch double-sided drive; 1.44 megabyte capacity
To Next Page
Loading...
