To Next Page

To Previous Page

Figure 103. Removing the service access cover from a rack-mounted system

For a stand-alone system, complete the following steps. Refer to Figure 104 on page 109.

Attention:

Operating the system without the service access cover on for more than 10 minutes

when the system power is turned on might damage the system components.

a. Release the latch by pushing the release latch (A) in the direction shown.

b. Slide the cover (B) off the system unit. When the front of the service access cover has cleared the

upper frame ledge, lift the cover up and off the system unit.

108

Power Systems: Power Systems: Control panel

Questions and Answers:

Need help?

Do you have a question about the IBM Power System 9009-41A and is the answer not in the manual?

IBM Power System 9009-41A Specifications

General

Processor	POWER9
Memory slots	16
Form factor	4U
Operating systems supported	AIX, IBM i, Linux
Processor cores	4
Processor threads	32
Processor speed	2.8 GHz
Maximum memory	1024 GB
Storage	SAS SFF Gen3 HDD/SSD, NVMe SSD