18. If you are not replacing the adapter with an identical adapter, place a blank slot
cover in the adapter slot and then lower the plastic stop over the adapter bracket.
Otherwise, insert the new adapter and rotate the locking latch clockwise until it
clicks into the locked position.
19. Continue to follow the screen instructions until you receive a message that the
adapter removal is successful. Successful removal is indicated by the OK message
displayed next to the Command field at the top of the screen.
20. Press F10 to exit the Hot-Plug Manager.
21. If you have added, removed, or replaced any adapters, run the diag -a command.
If the system responds with a menu or prompt, follow the instructions to complete
the device configuration.
22. If you have other adapters to remove, return to step 12 on page 35. If you do not
have other adapters to remove, install the covers that you removed earlier and
return the drawer to the normal operating position.
36 Installation Guide
To Next Page
Loading...
Need help?
General