2. Clean the four corner depressions on the bottom of the switch enclosure, place
an adhesive rubber foot in each one, and firmly press into place. The rubber
feet on the switch help prevent the switch from sliding off the supporting
surface.
3. Place the switch on a flat, sturdy surface.
4. Provide power to the switch as described in “Providing power to the switch”
on page 14.
Attention: Do not connect the switch to the network until the IP address is
correctly set. For instructions on how to cable and configure the switch, and how
to set the IP address, see “Configuring the switch” on page 14.
8 SAN24B-5 Installation, Service, and User Guide
To Next Page
Loading...
