Installation instructions
To install the switch in a slide-rail rack that meets EIA standards, use the following
procedure.
Attention: The switch must be turned off and disconnected from the fabric
during this procedure.
Complete these tasks to install the switch in a cabinet:
1. “Attaching the front brackets to the switch”
2. “Installing the switch in the cabinet” on page 11
3. “Attaching the rear brackets to the front brackets” on page 12
4. “Attaching the rear brackets to the cabinet rails” on page 13
Note: The illustrations in this section show the SAN48B-5 switch. Procedures and
positioning are the same for the SAN24B-5.
Attaching the front brackets to the switch
Complete the following steps to attach the front brackets to the switch.
1. Position the right front bracket 1 with the flat side against the right side of
the switch, as shown in Figure 4 on page 11.
1
2
3
4
5
6
7
8
9
b48f001
Figure 3. Items in the slim rail rack mount kit
10 SAN24B-5 Installation, Service, and User Guide
To Next Page
Loading...
