Serial port specifications
The serial port is located on the port side of the switch. The switch uses an RJ45
connector for the serial port. An RJ45 to DB9 adaptor cable is also provided with
the switch.
Note: To protect the serial port from damage, keep the cover on the port when not
in use.
The serial port can be used to connect to a workstation to configure the switch IP
address before connecting the switch to a fabric or IP network. The serial port’s
parameters are fixed at 9600 baud, 8 data bits, and no parity, with flow control set
to None.
Table 15 lists the serial cable pinouts.
Table 15. Serial cable pinouts
Pin Signal Description
1 Not supported N/A
2 Not supported N/A
3 UART1_TXD Transmit data
4 GND Logic ground
5 GND Logic ground
6 UART1_RXD Receive data
7 Not supported N/A
8 Not supported N/A
Access Gateway default port mapping
Table 16 lists the port mappings of F_Ports to N_Ports.
Table 16. Access Gateway default port mapping
Total
Ports F_Ports N_Ports Default port mapping
24 0-15 16-23 0, 1 mapped to 16
2, 3 mapped to 17
4, 5 mapped to 18
6, 7 mapped to 19
8, 9 mapped to 20
10, 11 mapped to 21
12, 13 mapped to 22
14, 15 mapped to 23
Appendix. Product specifications 43
To Next Page
Loading...
