Use the following steps to disable Access Gateway mode using Fabric OS
commands.
1. Enter the switchShow command to verify the switch mode.
v Access Gateway Mode displays if the switch is in Access Gateway mode.
v Native displays if the switch is in Fabric OS Native mode.
2. Enter switchDisable to disable the switch. Access Gateway mode can only be
disabled or enabled when the switch is in a disabled state.
3. Enter ag --modeDisable to disable Access Gateway mode.
4. Enter the ag --modeShow command to verify that Access Gateway mode is
disabled.
switch:admin> ag --modeshow
Access Gateway mode is NOT enabled
Chapter 2. Installing and configuring the switch 23
To Next Page
Loading...
