3525
Stop Indications and Restart Procedures (cont'd)
INDICATION DISPLAYED: MACHINE CHECK, PRESS
START
RECOVERY PROCEDURE:
1. Press
the
start
key.
NOTE:
The
permanent
error
key
is
operative during
this
stop.
INDICATION DISPLAYED: NPRO, 3 CARD RUN
IN
RECOVERY PROCEDURE:
1. Remove cards from
hopper
and examine
throat
area.
If partially·fed card
is
stuck in
throat,
remove it, repair
or
replace
it,
and
put
it
on
bottom
of
stack removed from hopper.
b. Remove
any
dust
or pieces
of
paper from
throat
area.
2.
Empty
stacker
1.
3. NPRO (press
the
NPRO key.)
4. •
If
3 CARD RUN
IN
is
blinking, discard first card
that
entered
stacker 1; place
any
other
stacker 1 cards in hopper.
If 3 CARD RUN
IN
is
not
blinking, place all cards
that
entered
stacker 1 in hopper.
5.
Place cards removed from
hopper
back
into
hopper.
6. Press the
start
key.
NOTE:
The
permanent
error
key
is
operative during this stop. During
NPRO,
three
cards should
enter
stacker 1 unless
one
card was
stuck in
throat;
if
card was stuck in
throat,
two
cards should
enter
stacker
1.
INDICATION DISPLAYED: JAM, PERMANENT ERROR
RECOVERY PROCEDURE:
1. Manually remove all cards from
the
card transport.
2. Perform
the
procedure
specified by
the
source program
INDICATION DISPLAYED: JAM, MACHINE CHECK, PERMANENT
ERROR
RECOVERY PROCEDURE:
1. Manually remove all cards from
the
card transport.
2. Perform
the
procedure
specified
by
the
source program.
INDICATION DISPLAYED: JAM, PRESS START,
MISSElECT
RECOVERY PROCEDURE:
A pu
nch
error
occurred
and
the
error
card failed
to
enter stacker 3.
Page
5·20
1. Examine
the
last cards
to
enter
stackers 1 and 2
for
a card containing a
punch
error. Place this card
in
stacker 3.
2. Press
the
start
key.
NOTE:
The
permanent
error
key
is
operative during this stop.
To Next Page
Loading...
