3525
Stop Indications and Restart Procedures (cont'd)
INDICATION DISPLAYED: JAM, PRESS START, MISSELECT, STACKER 3
RECOVERY PROCEDURE;
For a non-punch
or
read-punch job,
1.
Examine stacker 3 for error-free data cards misselected into
the
stacker.
2.
Place these cards in stacker 1
or
stacker
2,
as appropriate.
3. Press
the
start key.
For an unknown job,
1.
Examine
all
stackers for m;sselected cards.
2.
If correct stacker can be determined, place cards in correct stacker and
press start key.
3. If correct stacker
cannot
be determined, post penn anent error.
NOTE:
The
permanent error key
is
operative during this stop.
INDICATION DISPLAYED: PRINT
SKEW, PRESS START
RECOVERY PROCEDURE:
1.
Inspect the last 2 cards
in
each stacker for skewed printing. If neces-
.
sary,
manually reproduce
and
print
the
cards,
or
place them aside for
later reproduction.
2.
Replace these cards
in
their correct stackers.
3. Press
the
start key.
NOTE: The permanent error key
is
operative during this stop.
INDICATION DISPLAYED:
NPRO, PERM ERROR
RECOVERY PROCEDURE:
1.
Press stop key,
then
logout key. If logout number
is
4 and 2 on upper line
and the lower line
is
blank, go to step
4.
Otherwise, go
to
step
2.
2.
Check for card jam between punch and
print
stations. If there
is
a jam,
remove cards from transport, then go
to
step 4. If no jam exists,
go
to
step 3.
3.
Did
someone NPRO a job without NPRO
or
PERM ERROR lighted? If
so, restart
the
job. If not, cancel
the
job and have
the
program cor-
rected.
4. Perfonn
the
procedure specified by
the
source program. During this
procedure, run cards
out
of
the
lransport by pressing
the
NPRO key.
Page
5-21
To Next Page
Loading...
