3525
Stop Indications and Restart Procedures (cont'd)
INDICATION DISPLAYED: 3 CARD
RUN
IN
RECOVERY PROCEDURE:
The recovery from
the
previous error has
not
been completed.
1.
•
If
3 CARD
RUN
IN
is
blinking, clear
the
transport and discard
the
card
at
the print station.
If 3 CARD
RUN
IN
is
not blinking, clear
the
transport,
but
do
not
discard the card.
2. Continue with the recovery procedure being performed when this display
If
you are starting a new job, press the permanent error key twice
to
cancel the
recovery. CAUTION: Pressing
the
key cancels
the
recovery and recovery
cannot
be
accomplished.
INDICATION DISPLAYED: PERMANENT ERROR
RECOVERY PROCEDURE:
If this indicator
is
lighted and you did
not
press
the
permanent error key de-
liberately, press
the
permanent error key to turn the light off. This will ensure
that
a permanent error indication posted for the last job, (or one resulting from
an
unintended depression of
the
permanent error key) will
not
be associated with
the present job.
INDICATION DISPLAYED: STACKER 3
RECOVERY PROCEDURE:
The stacker 3 indicator can
be on either alone
or
in
combination with other
indications. It comes on when a card enters
the
reject stacker and remains on
until
the
start key
is
pressed.
If
the
job being processed
is
a data security
job-that
is,
if
it
is
important for
the
cards or the information they contain
to
be kept under
security-the
reject stack·
er (stacker
3)
must be emptied, as part of the restart procedure before
the
start
key
is
pressed, and
at
the end of
the
job. Nonsecurity error cards should
be
collected
for
the
customer engineer's examination.
INDICATION DISPLAYED: 3 CARD
RUN
IN, PRESS START
RECOVERY PROCEDURE:
1. Ensure
that
the
last card stacked entered
the
correct stacker.
2. Remove cards from the transport manually, keeping them in sequence.
3. Repair or
reproduce any damaged cards offline; reassemble cards
in
correct sequence and place them with undamaged cards.
4. Place last three cards below the cards
in
the hopper.
5. Place remaining cards in correct stacker
or
stackers.
6. Press the start key.
NOTE: The permanent error key
is
operative during this stop.
Page
5·23
To Next Page
Loading...
