To Next Page

To Previous Page

Upgrading the hard disk drive

You can increase the storage capacity of your computer by replacing the hard

disk drive with one of greater capacity. You can purchase a new hard disk

drive from your IBM reseller or IBM marketing representative.

Note: Replace the hard disk drive only if you upgrade it or have it repaired.

The connectors and bay of the hard disk drive were not designed for

frequent changes, or drive swapping.

Attention

Handling a hard disk drive

v Do not drop the drive or subject it to physical shocks. Put the drive on

a material, such as soft cloth, that absorbs the physical shock.

v Do not apply pressure to the cover of the drive.

v Do not touch the connector.

The drive is very sensitive. Incorrect handling can cause damage and

permanent loss of data on the hard disk. Before removing the hard disk

drive, make a backup copy of all the information on the hard disk, and

then turn the computer off. Never remove the drive while the system is

operating, in standby mode, or in hibernation mode.

To replace the hard disk drive, do the following:

1. Turn off the computer; then disconnect the ac adapter and all cables

from the computer.

2. Close the computer display, and turn the computer over.

3. Remove the battery.

4. Remove the screw that secures the hard disk drive.

5. Open the computer display; then stand the computer on its side and

remove the hard disk drive by pulling the cover away from the

Upgrading the hard disk drive

ThinkPad

T40 Series Service and Troubleshooting Guide

Other manuals for IBM ThinkPad T40 series

Questions and Answers:

Need help?

Do you have a question about the IBM ThinkPad T40 series and is the answer not in the manual?

General