To Next Page

To Previous Page

August 15, 2017

See the section on Creating a New Primary/Secondary Copy after Disaster Recovery for an example of how

to re-establish a secondary copy pool so that copy export can be performed against the recovery TS7700.

If you left the “Disaster Recovery Test Mode” checkbox checked, then the TS7700 will ignore the storage

management construct setting as logical volumes are accessed and closed. If you are only going to read data,

there is no need to change the storage management construct actions. If you create new volumes or modify

an existing volume, then the storage management construct actions will be followed and unless changed,

will follow what had been defined by the source TS7700.

You can now vary the recovery TS7700’s virtual drives online to its attached hosts. If you have not already

done so, you would now need to restore the host environment.

Questions and Answers:

Need help?

Do you have a question about the IBM TS7700 Series and is the answer not in the manual?

IBM TS7700 Series Specifications

General