1. Read the safety information that begins on page v and “Installation guidelines”
on page 22.
2. Turn off the server and peripheral devices and disconnect all external cables
and power cords.
3. Unlock the side cover and remove the lower bezel (see “Removing the
two-piece bezel” on page 26).
4. Touch the static-protective package that contains the drive to any unpainted
metal surface on the server; then, remove the drive from the package and place
it on a static-protective surface.
5. Align the drive assembly with the guide rails in the bay (the connector end of
the drive goes in first).
Bezel
6. Pull the blue loops of the drive assembly toward each other; then, carefully slide
the drive assembly into the drive bay until it stops, and release the loops.
Note: Do not release the loops on the drive assembly until it is completely
seated.
If you have other devices to install or remove, do so now; otherwise, go to
“Completing the installation” on page 47.
Installing an adapter
The following notes describe the types of adapters that the server supports and
other information that you must consider when you install an adapter. Adapter that
the server supports might vary, depending on your server model.
38 System x3100 M3 Type 4253: Installation and User’s Guide
To Next Page
Loading...
