The arrow moulded on the body shows the direction of water flow.
The pump should be installed in such a way that the junction box with the
control box is at the top, on the body of the motor. This will prevent water from
getting inside the junction box if the installation is not leaktight. This type of
equipment damage is not covered by the warranty and any repairs will have to
be paid for.
Although the pump can circulate water vertically down, the pump’s
manufacturer recommends that the pump circulates water vertically up or
horizontally.
ELECTRICAL CONNECTION:
The pump’s power supply network should satisfy the requirements listed on the
rating plate. The pump has a cable with a plug which can be inserted into an
earthed socket.
The pump needs to be connected to a network with an active earthing
system. The manufacturer and the guarantor will bear no responsibility for
injuries to people or any damage caused by the lack of an appropriate earthing
system.
The electrical installation which supplies power to the pump should be
equipped with an earth fault breaker for rated current which does not exceed
30 mA. The manufacturer and the guarantor will bear no responsibility for
injuries to people or any damage caused by the pump’s power supply failure due
to the lack of an appropriate breaker.
To Next Page
Loading...
