ICECO VL35 are fitted with a red LED error light inside the compressor compartment. If your ICECO cuts out or
will not operate, look inside the compressor compartment for a flashing red LED light. The number of flashes
corresponds to the following error type.
NO. OF
FLASHES
ERROR TYPE
1 BATTERY PROTECTION CUT-OUT
The voltage is outside the cut-out setting, Refer to VOLTAGE ISSUES below.
2
FAN OVER-CURRENT CUT-OUT
The fan loads the electronic unit with more than 0.5A avg.
3
MOTOR START ERROR
The rotor is blocked or the differential pressure in the refrigeration system is too high (
>5 bar).
4
MINIMUM MOTOR SPEED ERROR
Refrigeration system is too heavily loaded. Motor cannot maintain minimum speed approx 1,850 rpm.
5
THERMAL CUT-OUT OF ELECTRONIC UNIT
Refrigeration system too heavily loaded or ambient temperature is high. Electronic unit will run too hot.
6
THERMOSTAT FAILURE
If the NTC thermistor is short-circuit or has no connection.
CUT IN / CUT OUT
● Your fridge has built in battery protection and needs a minimum 10.9V to start and 9.6V to continue operating.
● During operation a load is placed on the power supply and voltage can drop by as much as 2V, especially if the
wiring in insufficient (less than 6mm direct to battery) or if there is a loose connection somewhere.
● If this occurs when you try and start your ICECO and the power supply drops under 10.9V it will not start.
If this occurs when your ICECO is running and the power supply drops below 9.6V it will stop.
RED LED ERROR LIGHT
REPAIR CAR WIRING
OR BATTERY
REPLACE
CONTROL PANEL
(CONTACT HEAD OFFICE)
REPLACE LEAD OR
REPAIR CONNECTION
(1) USE A DIFFERENT POWER SUPPLY
Run the fridge using a 240V to 12V adaptor. If
not available, use a different outlet with the car
running, or in a different car.
(2) OVERIDE THE CONTROL PANEL
Flick the override switch located on the back
of the ICECO control panel, then turn on the
fridge.
FRIDGE RUNS
FRIDGE RUNS
FAULTY CONNECTION
We solve 9 out of 10 ICECO issues by using this flow chart:
TROUBLESHOOTING FLOW CHART
(3) CHECK ALL CONNECTIONS
Check all connections and solder points
inside all sockets and plugs. Check your car
12V socketconnection by turning on the fridge
and wiggling the connections to see if the
power light flickers.
5
TROUBLE SHOOTING
To Next Page
Loading...
Need help?
General
