Iceco VL75 ProD - Page 16

2. The compressor will break down at ambient
temperatures above 55°C. Try to avoid using the
refrigerator at high ambient temperatures.
Make sure there is enough space outside the
compressor cover to dissipate heat (more than 5cm
on the left and right sides and 10cm space on the
front air outlet). Check that the cooling fan terminals
are connected tightly. A non-functioning cooling fan
will result in the compressor being unable to dissipate
heat and the temperature will rise.
13
Minimum motor speed error, the compressor is
over-loaded, and the motor cannot maintain
its minimum speed of 1850 rpms.
E4 Error Code
1. Make sure to turn o the machine and wait for
5 minutes before turning it on again.
If the compressor starts and then stops a few
seconds later, it is an E1 fault, and you need to refer
to the above E1 troubleshooting method for
troubleshooting;
E4 Solutions
13
E4
Error Code
Minimum motor speed error, the compressor is
over-loaded, and the motor cannot maintain its
minimum speed of 1850 rpms.
Solutions
1. Make sure to turn o the machine and wait for 5
minutes before turning it on again. If the compressor
starts and then stops a few seconds later, it is an E1
fault, and you need to refer to the above E1
troubleshooting method for troubleshooting;
2. The compressor will break down at ambient
temperatures above 55°C. Try to avoid using the
refrigerator at high ambient temperatures. Make
sure there is enough space outside the compressor
cover to dissipate heat
(more than 5cm on the left and right sides and 10cm
space on the front air outlet).
Check that the cooling fan terminals are connected
tightly. A non-functioning cooling fan will result in the
compressor being unable to dissipate heat and the
temperature will rise.