Iceco VL75 ProD - Error Code and Solutions; Code Description

Error Code And Solutions
3
Error Code And Solutions
5
10
Code Description
E1
The DC Voltage is below the protection settings
and the battery protection mode is activated.
E2
The cooling fan is over-loaded with more than 1A
of current.
E3
Repeated switching of the machine or a faulty
input voltage causes this motor start error.
The pressure dierence in the refrigeration
system is too high.
E4
Minimum motor speed error, the compressor
is over-loaded, and the motor cannot maintain
its minimum speed of 1850 rpms.
E5
Compressor control module temperature too high
or too low protection. (ambient temperature is too
high or too low, or the system load is too high,
causing the internal temperature of the module
/ECU > 212°F or< 14°F)
E6/LL
The temperature sensing head is loose or damaged.
HH
NTC failure (short circuit)
Error Code And Solutions
3
Error Code And Solutions
4
10
Code
Description
E1
The DC Voltage is below the protection settings
and the battery protection mode is activated.
E2
The cooling fan is over-loaded with more than
1A of current.
E3
Repeated switching of the machine or a faulty
input voltage causes this motor start error. The
pressure dierence in the refrigeration system
is too high.
E4
Minimum motor speed error, the compressor is
over-loaded, and the motor cannot maintain its
minimum speed of 1850 rpms.
E5
Compressor control module temperature too
high or too low protection. (ambient
temperature is too high or too low, or the system
load is too high, causing the internal
temperature of the module/ECU > 212°F or < 14°F)
E6/LL
The temperature sensing head is loose or
damaged.
E7/HH
NTC failure (short circuit)