MANUAL for KG30 - KG50 SUpreMe
DRY ICE BLASTING EQUIPMENT FROM ICETECH | PAGE 10
STARTING THE DRY ICE BLASTING MACHINE
2
1
3
3
4
5
6
7
Setting Up
1 Make sure the machine is on a level, horizontal
surface, and that the wheel brakes are applied.
2 Plug the blasting hose couplings into the socket
on the machine front and the blasting gun,
respectively.
Check to make sure the hose couplings are
correctly connected.
3 Connect the signal cable at both ends of the
blasting hose with the sockets on the machine
front and the blasting gun.
CORRECT ORDER IS IMPORTANT!!
FIRST connect the blasting hose couplings
– THEN the signal cable!!
4 Connect the main power supply.
5 Connect the compressed air supply.
Starting
When the machine has been set up as described
above (items 1-5), the following procedure shall
be followed before the cleaning process has
begun:
6 Check carefully to ensure that the dosing unit
is dry and clean at the hopper outlet.
7 Open the external compressed
air supply (slowly).
22
To Next Page
Loading...
Need help?
General
