iCharger 406DUO - Page 42

406DUO V1.2.0
Synchronous Balance Charger/Discharger
- 42 -
30XX
"Balance required!"
Balance port is unplugged
31XX
"Auto detect the number of cells failed, please
connect balance or set cells"
Check connection or balance port
32XX
"AD watchdog error"
AD watchdog error
33XX
"Synchronous mode: Channel outputs imbalance"
Channel outputs are imbalance in
Synchronous mode
34XX
"This channel is needed to access the resistor or
bulb load"
This regenerative channel is needed
to access the resistor or bulb load
35XX
"The other channel is occupied"
The other channel is occupied
Calibration
Setup
Interface
Manufacture
rs Default:
Default value
User
Calibration:
User
calibration
The user
calibration
may lead to
large data
deviation,
and
affecting the
normal use.
User
calibration
for charger
is not
recommend
ed.
Low
Voltage
Limit:
9V-48V;
default: 10V
Current
Limit:
1A-65A;
default: 65A
1:
Regenerative
Enable
2. Regen.
Voltage
Limit:
9V-48V;
default:
14.5V
3. Regen.
Current
Limit:
1A-65A;
default: 10A
T i c k
Regenerativ
e enable to
a c t i v e
p o w e r
s u p p l y
regenerativ
e feature,
enable the
charger to
c h a r g e
back to the
p o w e r
supply in
t h e
discharge
p r o c e s s .
Low
Voltage
Limit:
9V-48V;
default: 10V
Current
Limit:
1A-65A;
default: 65A