iCharger 406DUO - Important Notes; The Charging Principle for Reflex Charge Mode; Power Regenerative Mode; Channel Regenerative Mode

406DUO V1.2.0
Synchronous Balance Charger/Discharger
- 38 -
Important Notes
 The Charging Principle for Reflex Charge Mode
 Power Regenerative Mode
 Channel Regenerative Mode
Channel Regenerative Mode is the feature for discharging from one channel to another channel, which supports resistor
discharge, bulbs discharge, and charging battery.
 Resistance or Bulbs
Note: Reflex charge mode only supports NiMH and
Pb battery. It does not support lithium battery.
Using reflex charge mode to charge battery can
reduce effectively the heating of the battery. Go to the
MEMORY SETUP → Charge → Chg Mode to select
Reflex mode.
Note: Power Regenerative Mode: which is when the
power supply for the charger acts as "battery power",
the charger will regenerative charge for "battery
power" during the process to discharge the battery.
Go to MEMORYSETUP → Discharge → Regenerative
-Mode to select To input mode.
1: Regenerative power
2: Regenerative voltage limit
3: Regenerative current limit
1
2
3
Resistance or bulbs as the load:
1. Connect the resistance or bulbs to any channel of
the charger;
2. In another channel of the charger, MEMORY
SETUP→ Discharge→ Regenerative Mode→ To
channel, to select Resistance or bulbs，then connect
the battery for discharging to this channel, and start
the discharge program to discharge the battery.
Press STOP/START button to end the program
during the period.