How to fix Icom A25N 46 USA that does not turn on?
If your Icom Transceiver does not turn on, there could be a few reasons. First, the battery might be exhausted, in which case you should recharge it. Second, the battery pack may not be correctly attached; try reattaching it properly. Lastly, if you are using the CP-20, its fuse might be blown. If so, repair the underlying problem and then replace the fuse.
Why Icom A25N 46 USA will not transmit?
If you cannot transmit with your Icom Transceiver, ensure that you have selected a COM band frequency, as you cannot transmit on a weather channel or VOR frequency. Also, check if the battery is exhausted and recharge it if necessary.
What to do if Icom A25N 46 USA keypad is locked?
If your Icom Transceiver displays “Locked” when you push keypad keys or rotate [DIAL], the keypad and [DIAL] are likely locked. To unlock them, push [F], and then push [ ].
Why scan does not start on Icom A25N 46 USA Transceiver?
If the scan function does not start on your Icom Transceiver, it may be because all memory channels in the selected group are not tagged. To resolve this, tag memory channels on the Menu screen.
How to turn on beep sound on Icom Transceiver?
If you are not hearing any beep sounds on your Icom Transceiver, the beep output level may be set to OFF. Adjust the beep output level on the Menu screen by going to [MENU] > Sounds Settings > Beep.
General| Channel Spacing | 25 kHz / 8.33 kHz |
|---|---|
| Power Supply Requirement | 7.2 V DC |
| GPS | Yes |
| Bluetooth | No |
| Type | Handheld Transceiver |
| Battery | Li-ion |
| Weight | 0.36 kg (0.79 lbs) |
| Dimensions | 58 x 140 x 36 mm (W x H x D) |
| Operating Temperature Range | -10°C to +60°C |
| Modulation | AM |
To Next Page
