Icom F2000T 84 USA - Page 11

8
1
1
PANEL DESCRIPTION
SURVEILLANCE
< for the Non-display type transceivers >
Hold down to turn ON the Surveillance function. ➥
Push to turn OFF the function. ➥
< for the Simple type and 10-key type transceivers >
Push to turn the Surveillance function ON or OFF. ➥
• When this function is ON and a signal is received, a
beep does not sound and the LED does not light, even if
you push any key.
SIREN
Hold down to emit a siren sound. ➥
• This function may use for situations other than an emer-
gency alert, such as a security alarm.
Turning OFF the transceiver power to stop the siren ➥
sound.
TX CODE ENTER
// only for the PMR model (for the Simple type and
10-key type transceivers) //
Push to enter the TX code edit mode (5-Tone). ➥
1.
P u s h [CH Up] or [CH Down] to select the desired digit.
You can also enter the digit using the 10-key pad, if it is
on your transceiver.
2. Push [TX Code Enter] to set. The digit to the right will
automatically blink.
3. Repeat step 1 and step 2 to input all editable digits.
4. After editing, push [TX Code Enter] to store the setting
and return to the standby mode.
TX CODE CH SELECT
// only for the Simple type and 10-key type transceivers //
Push ➥ [TX Code CH Select] to enter the TX code channel
selection mode.
1. Push [CH Up] or [CH Down] to select a desired TX
code channel.
2. After selecting, push [TX Code CH Select] to store the
setting and return to the standby mode.
// only for the PMR model //
During TX code selection mode, hold down to enter the TX ➥
code edit mode (5-Tone).
1.
P u s h [CH Up] or [CH Down] to select the desired digit.
You can also enter the digit using the 10-key pad if it is
on your transceiver.
2. Push [TX Code Enter] to set. The digit to the right will
automatically blink.
3. Repeat step 1 and step 2 to input all editable digits.
4. After editing, push [TX Code Enter] to store the set-
tings and return to the standby mode.
TX CODE CH UP/DN
// only for the LMR model (for the Simple type and
10-key type transceivers) //
Push to select a preprogrammed TX code channel. ➥