Icom F2000T 84 USA - Setting the Beep Function

16
2
BASIC OPERATION
2
16
15
14
13
12
11
10
9
8
7
6
5
4
3
1
■ Setting the Beep function
These instructions are for the non-display type transceivers.
The Beep function can be turned ON or OFF. When it is OFF,
the channel announcement is also turned OFF.
NOTE:
You should turn ON the Beep function when you set the
Beep level, the Ringer level, the microphone gain, and the
squelch level.
Rotate q [VOL] to turn the transceiver power OFF.
Set w [ROTARY SELECTOR] to any channel other than
Channel 16.
While holding down e [Lower], rotate [VOL] to turn ON the
power to enter the Beep level adjustment mode.
P u s h r [Lower] to turn the Beep function ON or OFF.
• When a beep sounds after pushing [Lower], the Beep function
is ON. When no beep sounds after pushing [Lower], the Beep
function is OFF.
• The transceiver stores the setting every time you change it.
• If desired, push [Upper] to adjust the Beep level. See page 17
for details.
Rotate t [VOL] to turn OFF the power to exit the Beep level
adjustment mode.
[ROTARY SELECTOR]
[VOL]
[Lower]
[Upper]