Icom IC-4008E - Group Mode; Setting the Group Code

11
6
‘‘
Setting the group code
The IC-4008E is equipped with 38 group codes. Group mode op-
eration provides communication with silent standby since you will
only receive calls from group members using the same group num-
ber.
First of all, set the same group code number for all group member’s
transceivers.
Turn ON the group mode operation:
q Push [MODE] to enter set mode.
•“ --- ” (group mode OFF) appears on
the display.
w Push [UP]/[Y] or [DOWN]/[Z] to select
the desired code number.
e Push [MODE] to set the group code
number.
Cancel the group mode operation:
q Push [MODE] to enter set mode.
• Code number disappears on the dis-
play.
w Push [UP]/[Y] or [DOWN]/[Z] to select
“ --- ” (group mode OFF).
e Push [MODE] to cancel the group
mode.
NOTE: Only stations with the same group channel number can
be heard during group mode operation, even when the busy in-
dicator appears on the display.
UP
DOWN
M
OD
E
P
O
W
E
R
q
w
w
GROUP MODE (CTCSS)
IC-4008E-2 02.3.23 3:26 PM Page 16 (1,1)