Icom IC-4008E - Ring Function; Smart-Ring; Call-Ring

14
7
RING FUNCTION
‘‘
Smart-Ring
The ring function has an answer back feature. This allows you to
confirm whether or not a call has reached the receiving party even
if the operator is temporarily away from the transceiver.
q Set the same group channel number for
all of your group transceivers. (See left.)
w While pushing [PTT], push [UP]/[Y] .
• A beep is emitted and “ ” blinks on
the display.
e Release the [PTT].
• When a member of your group an-
swers your call, the transceiver emits
beep tones for 10 sec. and blinks “ ”.
• When no answer comes back, the
transceiver emits short faint beep tones.
r Push [PTT] to answer and to stop the beeps and flashing.
NOTE: This function is available only when the called station
has set the same group number and the same operating chan-
nels as you.
‘‘
Call-Ring
Sends the ring tones during transmit
mode.
➥ While pushing [PTT], push [DOWN]/[Z]
to send a ring tone.
• The ring tone is emitted while pushing
[DOWN]/[Z].
• The microphone signal is automati-
cally cut while pushing [DOWN]/[Z].
UP
DOWN
M
O
D
E
P
O
W
E
R
UP
DOWN
M
O
D
E
P
O
W
E
R
IC-4008E-2 02.3.23 3:26 PM Page 19 (1,1)