Icom IC-410PRO - Set Mode Items; D Set Mode Sequence

3
SET MODE
3-2
D Set mode sequence
The table below describes the sequence of the items in the Set mode.
• The sequence is as shown below when you push [FUNC] in the Set mode.
Set mode items
• Squelch level
Starting item
• Own ID*
2
*
3
• Scan mode
• CTCSS/DTCS*
1
• Backlight
• Beep
• Beep Level
• RF Power • Quiet mode
• Lockout
• Roger Beep
• Battery Voltage
• Auto Power Off
• Signal Monitor
• Horn • RX VFO
• Scan Stop Timer
• Scan Restart
• Mic Gain
• Lone Worker*
2
• AF Minimum Level*
2
*
1
Selected CTCSS or DTCS code is displayed.
*
2
May not be displayed, depending on the transceiver’s setting.
*
3
5 digit Own ID is displayed.