Icom IC-410PRO - General Specifications; Transmitter Specifications; Receiver Specifications

9-2
Specications
D General
• Frequency coverage:
CB 476.4250–477.4125 MHz
RX/Private 450.0000–520.0000 MHz
• Type of emission:
CB 8K50F3E
RX/Private 8K50F3E/16K0F3E
• Channel spacing:
CB 12.5 kHz
RX/Private 12.5/25 kHz
• Current drain (at 13.8 V):
TX (at 5 W) approximately 4.0 A
TX (at 25 W) approximately 7.0 A
Max. audio approximately 1200 mA
• Operating temperature range: –30°C to +60°C
• Power supply requirement: 13.8 V DC nominal (Negative ground)
• Frequency stability: ±2.5 ppm (–30°C to + 60°C)
• Antenna impedance: 50 Ω nominal
• Dimensions: W 150 × H 40 × D 117.5 mm (Projections not included)
• Weight: approximately 800 g
D Transmitter
• Output power:
CB 5 W/1 W
Private 25 W/5 W/1 W
• Modulation system: Variable reactance frequency modulation
• Max. frequency deviation:
Narrow ±2.5 kHz
Wide ±5.0 kHz
• Spurious emissions: –30 dBm (maximum)
D Receiver
• Sensitivity (12 dB SINAD): 0.25 μV (typical)
• Squelch sensitivity: 0.25 μV (typical)
• Intermodulation rejection ratio: 75 dB (typical)
• Spurious response rejection ratio: 70 dB (minimum)
• Audio output power: 4.0 W (typical) at 5% distortion into a 4 Ω load
All stated specications are subject to change without notice or obligation.
9
SPECIFICATIONS