Icom IC-41PRO - OPTIONS (Continued); Battery Pack Options; Charger Options; DC Cable Options

11
4
OPTIONS
D BATTERY PACKS
• BP-280/BP-279/BP-278 battery pack
Battery pack Voltage Capacity Battery life*
BP-280
7.2 V
2280 mAh (minimum)
2400 mAh (typical)
18 hours
BP-279
1485 mAh (minimum)
1570 mAh (typical)
12 hours
BP-278
1130 mAh (minimum)
1190 mAh (typical)
9 hours
* When the Power Save function is turned ON, and the operating
periods are calculated under the following conditions:
TX : RX : standby = 5 : 5 : 90
D CHARGERS
• BC-213 desktop charger + BC-123SV ac adapter
To rapidly charge a single battery pack.
• BC-214 multi charger + BC-157S ac adapter
To rapidly charge up to 6 battery packs.
D DC CABLES
• CP-23L cigarette lighter cable
Enables charging the battery pack using a 12 V cigarette lighter
socket. (Use with the BC-213)
• OPC-656 dc power cable
Enables charging the battery pack using a 13.8 V power source
instead of the power adapter. (Use with the BC-214)
D ANTENNA
• FA-SC73US stubby antenna
450–490 MHz
D OTHERS
• MB-130 mobile bracket
Mounts the BC-213 desktop charger in a variety of places in a
vehicle.
• MB-133 belt clip
• HM-153LA/HM-166LA earphone microphone
Ideal for hands-free operation. Clip the HM-153LA or HM-166LA
(with integrated PTT switch) to your lapel or breast pocket.
• HM-158LA/HM-159LA/HM-168LWP* speaker microphone
Combination speaker-microphone that provides convenient opera-
tion while the transceiver is hanging on your belt.
• HS-97 headset
+ VS-4LA ptt switch cable/OPC-2004LA adapter cable
HS-97: Throat microphone
VS-4LA: To connect the headset
OPC-2004LA: To connect to the headset for VOX operation
- Adjust both the microphone and VOX gain before use.
• HS-94LWP*/HS-95LWP* headset
hs-94lwp: Ear-hook type
HS-95LWP: Neck-arm type
- Adjust both the microphone and VOX gain before use.
* When in use, the transceiver meets IP67 requirements for dust-tight
and waterproof protection.
• CS-41PRO cloning software + OPC-478UC cloning cable
Enables quick and easy entry of settings such as RX frequencies
and Set mode contents.
Approved Icom optional equipment is designed for optimal performance when
used with an Icom transceiver. Icom is not responsible for the destruction or
damage to an Icom transceiver in the event the Icom transceiver is used with
equipment that is not manufactured or approved by Icom.