Icom IC-A210

11
3
MEMORY OPERATION
03
■ Programming example
The following is an example showing how to program 126.000 MHz into regular memory channel 4.
“ ” appears when no frequency
has been programmed into regular
memory channel 4.
“MEMORY” and regular memory
channel number appear.
“126.00” appears in the standby
indicator.
126.005
134.80
RX
CH01
134.80
RX
MEMORY
CH04
134.80
RX
MEMORY
CH04
126.000
---.---
134.80
RX
MEMORY
REPLACE Ç
CH04
126.005
134.80
RX
MEMORY
Set a “126.000 MHz” in the
standby indicator.
q
Push [RCL], then rotate [O-
DIAL] to select “MEMORY”.
w
Push [MEM], then rotate [O-
DIAL] to select “REPLACE.”
r
Push [MEM] to store the
desired frequency into the
selected regular memory
channel.
t
Select regular memory chan-
nel 4 with [DIAL].
e
“WRITE COMPLETED” is displayed
when the selected frequency is
stored.
Regular memory channel number
blinks.
TIP: Push and hold [MEM] for 2 sec. to program a displayed frequency to any blanket memory channel automatically, after step
q.
NOTE: The programming is cancelled while all regular memory channels have already programmed.
IC-A210.qxd 2007.07.24 2:06 PM Page 11