Need help?Do you have a question about the Icom IC-A22E and is the answer not in the manual?
General| Modulation | AM |
|---|---|
| Channel Spacing | 25 kHz / 8.33 kHz |
| Power supply requirement | 7.2V DC |
| Modulation Type | AM |
| Frequency Range | 118.000 - 136.975 MHz |
| Channels | 200 |
| Weight | 300 g |
| Current Drain | 1.5A |
| Voltage | 7.2V |
| Power Output | 5W / 1W |
| RF Output Power | 5.0W (PEP), 1.5W (carrier) |
Read all instructions carefully and completely before using the transceiver.
This manual contains important safety and operating instructions for the IC-A22 and IC-A22E.
Describes the controls and connectors on the front and side of the transceiver.
Details the controls and connectors located on the top of the transceiver.
Explains the function and secondary function of each key on the transceiver's keypad.
Identifies and explains the main indicators (transmit, receive, lock, function, frequency) on the transceiver's display.
Details additional display indicators related to VOR navigation, such as course, to-from flags, and deviation.
Instructions for charging the transceiver's battery pack before initial use.
Important warnings and safety guidelines regarding the handling and use of the battery pack.
Information on operating period, battery memory effect, and battery pack life.
Explains how to connect the wall charger for regular and rapid battery charging.
Details how to connect an external 12V DC power source for operation.
Steps for installing alkaline batteries into the optional battery case.
Instructions for attaching the antenna and belt clip to the transceiver.
How to quickly access the 121.5 MHz emergency frequency using the keypad.
Guide to setting operating frequencies using the keypad and tuning dial.
Instructions for setting frequencies and channels using the tuning dial.
How to activate and deactivate the key lock function to prevent accidental changes.
Steps for selecting and tuning into VHF marine weather channels (U.S.A. version).
How to set up and operate for receiving signals, including squelch adjustment.
Guide to transmitting signals, including PTT operation and microphone usage.
How to enable the side tone function for monitoring transmitted voice via headset.
How to select a desired memory channel using the tuning dial or keypad.
Procedure to transfer memory channel data into frequency mode.
Steps for programming frequencies, comments, and lockout/duplex info into memory.
Guide to creating and assigning 6-character comments to memory channels.
How to clear unwanted memory channels, with the exception of memory channel 1.
Overview of available scan types: COM band, memory, and weather channel scans.
Instructions for initiating and operating the COM band scan function.
How to perform a memory scan, skipping lockout channels.
Procedure for scanning weather channels (U.S.A. version only).
How to specify memory or weather channels to be skipped during scans.
Explanation of how VOR indicators (course, to-from flags) are displayed on the transceiver.
How to select CDI and DVOR modes for VOR navigation and display.
Steps to select the next VOR station while using CDI mode for navigation.
Guidance on using the transceiver to navigate towards or away from a VOR station.
How to input and display a desired course for navigation relative to a VOR station.
Method to determine aircraft position by intersecting radials from two VOR stations.
How to use the duplex function to communicate with a flight service station while receiving VOR.
Procedure to reset the transceiver's CPU, clearing all programmed settings.
To Next Page
