Icom IC-A220 - Page 32

25
5
MENU MODE
D Time-Out-Timer “TIME OUT”
To prevent accidental prolonged transmission, the transceiver
has a time-out-timer.The function inhibits continuous trans-
missions longer than the set time period.
• 020 to 240: Setting time-out-timer period from 20 seconds to 240
seconds in 10 second steps.
D Interlock “INTERLOCK”
If the transceiver is connected together with the other trans-
ceiver, the interlock function can prevent the transceiver from
receiving or transmitting while the other transceiver is trans-
mitting.
• ON: The interlock function is ON.
• OFF: The interlock function is OFF.
D Interlock mode “INTLOCK MODE”
Sets the desired function to be disabled by the interlock.
* Displayed only when the Interlock “INTLOCK” item in the Configura-
tion menu is set to “ON.”
• TX INHIBIT: Transmission is disabled.
• RX MUTE: Audio output is disabled.
• BOTH: Both transmission and audio output are disabled.
NOTE: The interlock mode is not displayed when the “TX/
RX INTERLOCK SW” item is set to “DISABLE.”
Ask your dealer for the “TX/RX INTERLOCK SW” setting
details.
D Remote exchange “REM SWAP”
Sets the remote control (p. 16) to use the frequency exchange
switch or not.
• OFF: The remote control for the frequency exchange switch
is OFF.
• ON: The remote control for the frequency exchange switch
is ON.
D Remote incom “REM INCOM”
Sets the remote control (p. 16) to use the intercom or not.
• OFF: The remote control for the intercom is OFF.
• ON: The remote control for the intercom is ON.
D Remote recall “REM RECALL”
Sets the remote control (p. 16) to use the recall switch or
not.
• OFF: The remote control for the recall switch is OFF.
• ON: The remote control for the recall switch is ON.
D Memory clear “MEM CLEAR”
Select a desired item to be reset.
After the selection, hold down [MEM] for two seconds to reset
the selected item’s contents.
• MENU: Reset the menu mode items setting to their defaults.
• MEMORY: Clear the stored memories except the weather memo-
ry channel.
• ALL: Reset the menu mode items setting to their defaults
and clear the stored memories.