Icom IC-A22E

* No power comes on. * The battery is exhausted.
power cable.
* [SQL] is turned too far counterclockwise.
* An optional cable or headset is connected.
* The lock function is activated.
No sound comes from the
speaker.
© Frequency cannot be set.
* The emergency frequency is selected,
* CDI mode is selected.
* Scan cannot be activated. | * The squelch is open.
* The lock function is activated,
«Frequency is not dis-
played.
Played.
* NAV band frequency is set.
* Weather channel is selected. (U.S.A. only)
* Transmitting is impossible.
© Resetting the CPU
CAUTION: Resetting the CPU clears and initializes all
programmed contents such as memory contents, lockout
channel settings, etc.
- While pushing [F], [0] and [ENT], turn power ON to reset
the CPU.
* Poor plug connection to the extemal DC
The memory channel comments are dis-
TROUBLESHOOTING
‘* Charge the battery pack or place new alkaline | pgs.
batteries in the battery case.
* Check the connector or remove and replace the =
cable.
* Rotate [SQL] clockwise.
* Unplug the cable or headset.
© Push [F] then [@KEY LOCK] to deactivate the
lock function.
* Push [CLR] to select frequency mode.
* Push [F] then [© DVOR] to select DVOR mode.
* Rotate [SQL] counterclockwise until noise dis-
appears.
* Push (F] then [KEY LOCK] to deactivate the
lock function.
* Push [MR] to toggle between a comment and
frequency,
‘* Set the frequency in COM band.
Push [CLR] to select frequency mode.
“CLEAR” appears momentarily, the default frequency appears
and the transceiver's CPU is reset.
fem ||
=
ENGLISH
8