1-1
SECTION 1
SPECIFICATIONS
M GENERAL
• Frequency range: 446.00625–446.09375 MHz
• Number of conventional channels: 16
• Type of emission (Occupied band-width): 8K50F3E (12.5 kHz)
• Operating temperature range: –25˚C to +55˚C
• Power supply voltage: Specified Icom's battery packs only (7.5 V DC: negative ground)
• Current drain (Approximately): Receiving 80 mA (stand-by)
300 mA (maximum audio, internal speaker)
Transmitting 0.5 A (at 0.5 W ERP)
• Dimensions (Projections not included): With BP-279
52.2(W) × 186.1
(H) × 24.5(D) mm
• Weight: With BP-279 240 g
• Intermediate frequency: 1st
2nd
46.35 MHz
450 kHz
• Input impedance (Microphone): 2.2 k
• Output impedance (Speaker): 8
M TRANSMITTER
• Output power: 0.5 W ERP
• Modulation: Variable reactance frequency modulation
• Maximum frequency deviation: ±2.5 kHz
• Frequency stability: ±2.5 ppm
• Spurious emissions: 0.25 µW (
1 GHz), 1.00 µW (
1 GHz)
• Adjacent channel power: 60 dB
• Audio harmonic distortion: 1.0% typical at AF 1 kHz 60% deviation
• Residual modulation (With CCITT FILTER): 48 dB typical
• Limiting charact of modulator: 60–100% of maximum deviation
M RECEIVER
• Sensitivity: 26.5 dBµ V/m at 20 dB SINAD
• Intermodulation: 86.29 dBµ V/m
• Spurious response: 91.29 dBµ V/m
• Audio output power: 0.8 W typical at 5% distortion into the 12
internal speaker.
0.4 W typical at 5% distortion into an 8
external speaker.
• Adjacent channel selectivity: 81.29 dBµ V/m
• FM Hum and noise (With CCITT FILTER): 47 dB typical
• Squelch sensitivity (Threshold): 26.5 dBµ V/m
Specifications are measured in accordance with EN 300 296.
All stated specifications are subject to change without notice or obligation.
To Previous Page
Loading...
