Icom IC-F4261DT - Section 3 Disassembly Instruction; Main Unit

3 - 1
SECTION 3
.
DISASSEMBLY INSTRUCTION
1. REMOVING THE FRONT UNIT
1) Remove 2 knobs and antenna nut from the front
panel.
2) Remove 2 screws from the chassis.
3) Disconnect fl at cables from J704, and then remove
the chassis from the front panel.
2. REMOVING THE MAIN UNIT
1) Remove 7 screws from the MAIN UNIT.
2) Disconnect fl at cables from J3 and J4, and then re-
move the MAIN UNIT from the chassis.
Remove with;
“ICOM Driver (K)”
(8960000110)
Antenna nut
Knob
Knob
JACK UNIT
J704
VR
flat cable
Release the locks
Pull straight
FLAT CABLE
Flat cable
Flat cable
BE CAREFUL about the locks.
Chassis
JACK UNIT
JACK UNIT
J704
Screws
VR
J704
Chassis
FRONT UNIT
JACK UNIT
J704
VR
Screws
MAIN UNIT
J5
flat cable
Release the locks
Pull straight
FLAT CABLE
Flat cable
Flat cable
BE CAREFUL about the locks.
Chassis
MAIN UNIT
Screws
JACK UNIT
J704
VR
J3
J4
flat cable
Release the locks
Pull straight
FLAT CABLE
Flat cable
Flat cable
BE CAREFUL about the locks.
BE CAREFUL about the flat cable when separating the
chassis from the front panel.
4) Remove 6 screws from the FRONT UNIT.
5) Disconnect the fl at cable from J5, and then remove
the FRONT UNIT from the chassis.
(Continue on the right column.)