10
3
BASIC OPERATION
D Despatcher call
A status is used for the despatcher call normally, however, the
direct despatcher call can be made according to the setting.
q Push [Despatcher] to select the despatcher call condition.
• “DESPATCH” is displayed.
DESPATCH
w Push [PTT] or [Call Set Up] to make the despatcher call.
• When the direct despatcher call is inhibited, the status message
“0 (call back request)” is transmitted, then returns to stand-by
condition.
• “CALLING” is displayed and the calling beeps sound.
CALLING
e When the call is succeeded, “CONNECT” and “ ” appear,
and communication can be made.
• The communication timer starts count down at the same time.
(When no transmission time limit is set, the timer counts up.)
CONNECT
TIM 0 56
r The warning beeps sound 10 sec. before the communica-
tion timer is activated.
• The communication is disconnected automatically when the
communication timer is activated.
t Push [Clear] to disconnect the communication manually.
• Pushing [M] and [#] in sequence also disconnect the communi-
cation. (10-key version only)
CLR DOWN
To Next Page
Loading...
