q TRANSMIT INDICATOR
Appears while transmitting.
w BUSY INDICATOR
Appears while the channel is busy.
e OVER-FLOW INDICATOR
Appears when the received SDM including more than 9
characters is displayed.
r SIGNAL STRENGTH INDICATOR
Appears when receiving a signal and shows the signal
strength levels in 4-steps.
• No bars appear and “ ” blinks when the transceiver is in out-of
service area. For stable communications, the transceiver should
be in the area that the S-meter indicator shows the full scales (3
bars) indication.
t LOW POWER INDICATOR
Appears when low output power is selected.
• When the battery power decreases to a specified level, low
power is selected automatically.
y AUDIBLE INDICATOR
Appears when the voice communication can be per-
formed.
u COMPANDER INDICATOR
Appears when the compander function is activated.
• The compander function improves communicating audio quality.
i SCRAMBLER INDICATOR
Appears when the voice scrambler function is activated.
o CALL BACK INDICATOR
➥Blinks when an individual call is received.
➥ Appears when individual calls that the call back opera-
tion has not been performed are available.
➥Disappears when replies to all individual calls.
!0 PRIMARY NETWORK INDICATOR
Appears when the transceiver is in the primary network
service area.
!1 KEY LOCK INDICATOR
Appears when the key lock function is turned ON.
!2 BATTERY INDICATOR
Appears or blinks when the battery power decreases to a
specified level.
!3 ALPHANUMERIC DISPLAY
Shows dialing number and received message, etc.
!4 SYSTEM LOCK INDICATOR
Appears when the system lock function is in use.
To Next Page
Loading...
