u 10-KEYPAD (Depending on version)
The keypad allows you to enter digits to:
• Set TX codes
• Set DTMF codes (during transmit)
• Input text message for SDM operation
• Start up with the password
i DESPATCHER KEY [P0] (p. 10)
➥Push to display despatcher call conditions.
➥Push again to display the status code, if permitted.
➥Push again to return to stand-by condition.
o CALL BACK KEY [P1] (p. 22)
➥ Push to display the received call record (call back mem-
ory) that had not replied.
➥Push again to return to stand-by condition.
➥ Push and hold for 2.5 sec. to toggle the call back mode
ON and OFF.
• When the call back mode is set to ON, the received call is
stored into record (log), and the call back message is send
back to the calling station automatically.
!0 UP/DOWN KEYS
➥Push to select the call memory channel.
➥Push to select the call back memory channel.
➥Push to select the status channel.
➥ Push to select the operating channel. (Conventional
mode operation only)
➥ Push to select the setting value or condition during user
set mode.
➥ Push to erase the previously entered digit number
(functions as back space key) during dialing number
entering from the keypad. (10-key version only)
!1 PTT SWITCH [PTT]
➥ Push to making a call with the displayed dialing num-
ber.
➥ When selecting a traffic channel for communication, or
conventional mode, push to transmit.
➥ When an individual call is received, push to reply the
call.
!2 CLEAR (SET MODE) KEY (pgs. 8, 26)
➥Push to finish the communication.
➥Push and hold to enter to the user set menu.
➥ During some function operation, push to return to stand-
by condition.
!3 ANTENNA CONNECTOR
Connects the supplied antenna.
Desired functions can be programmed into the [P0] to [P3],
[Red], [Clear], [Up] and [Down] keys independently by your
dealer. (p. 29)
5
2
PANEL DESCRIPTION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
To Next Page
Loading...
