11
2
BASIC OPERATION
D TX code number edit
(PMR operation only)
If the transceiver has [TX Code CH Select] or [TX Code
Enter] assigned to it, TX code contents can be edited within
the allowable digits.
USING [TX CODE CH SELECT] KEY:
q Push [TX Code CH Select] to enter the TX code channel
selection mode.
•Selectthe desiredoperatingchannel beforeenteringtheTX
code channel selection mode if necessary.
w Push [TX Code CH Select] for 1 sec. to enter the TX code
edit mode.
•Thedigittobeeditedblinks.
e Push [TX Code CH Select] to select the desired digit to be
edited.
r Push [CH Up] or [CH Down] to select the desired digit.
t Push [TX Code CH Select] to set. The digit to the right will
blink automatically.
y Repeat r and t to edit all allowable digits.
u After editing, push [TX Code CH Select] to set.
•Returntothestand-bymode.
i Push [Call] to transmit.
USING [TX CODE ENTER] KEY:
q Push [TX Code Enter] to enter the TX code edit mode.
•Thedigittobeeditedblinks.
w Push [TX Code Enter] to select the desired digit to be ed-
ited.
e Push [CH Up] or [CH Down] to select the desired digit.
r Push [TX Code Enter] to set. The digit to the right will blink
automatically.
t Repeat e and r to edit all allowable digits.
y After editing, push [TX Code Enter] to set.
•Returntothestand-bymode.
u Push [Call] to transmit.
D DTMF transmission
If the transceiver has [DTMF Autodial] assigned to it, the
automatic DTMF transmission function is available. Up to 8
DTMF channels are available.
q Push [DTMF Autodial]— a DTMF channel appears.
w Push [CH Up] or [CH Down] to select the desired DTMF
channel.
e Push [DTMF Autodial] to transmit the DTMF code.
To Next Page
Loading...
Need help?
General
