Icom IC-F5061/D

12
2
BASIC OPERATION
2
■ User set mode
User set mode is accessed with [User Set Mode] and allows
you to set seldom-changed settings. In this case you can
“customize” the transceiver operation to suit your prefer
-
ences and operating style.
Entering the user set mode:
q While pushing and holding [P1] and [P2], push [ ] to turn
the power ON.
• Turn power OFF in advance.
• You should hold [P1] and [P2] until “SET MODE” appears on
the display.
[P1] [P2] [ ]
w Push and hold [P0] for 1 sec. to enter user set mode.
[P0]
e Push [P0] several times to select the appropriate item.
Then, push [Up] or [Down] to set the desired level/condi
-
tion.
• Available set mode functions are Backlight, LCD Contrast,
Beep, Beep Level, Ringer Level, SQL Level, AF Min Level,
Mic Gain, Battery Voltage, Horn, Signal Moni and Lone
Worker.
[P0] [Up]/[Down]
r Push and hold [ ] for 1 sec. to turn power OFF, then ON
again to exit set mode.
[ ]
User set mode is also available using a programmable key.
Please refer to p. 7 [User Set Mode] section for instructions
regarding using the key assigned for user set mode.
NOTE: [Up], [Down] and [P0] activate while in the user
set mode regardless of the assigned key functions.