Icom IC-F5123D - Adjustment and Calibration Procedures; Preparation for Adjustments

11
2
BASIC OPERATION
2
■ User set mode
User set mode can be accessed with ‘Power ON’ function. In
this case, all set mode items are available.
User set mode allows you to set seldom-changed settings
and you can “customize” the transceiver operation to suit
your preferences and operating style.
Entering the user set mode:
q While holding down [P1] and [P2], push [ ] to turn the
power ON.
• Turn power OFF in advance.
• Hold down [P1] and [P2] continuously until “SET MODE” ap-
pears on the display.
[P1] [P2]
[ ]
w Hold down [P0] for 1 sec. to enter user set mode.
[P0]
e Push [P0] several times to select the appropriate item.
Then, push [Up] or [Down] to set the desired level/condi-
tion.
• Available set mode functions are Backlight, Beep, Beep Level,
Ringer Level, SQL Level, AF Min Level, Mic Gain, Horn, Bat-
tery Voltage, Signal Moni and Lone Worker.
[P0] [Up]/[Down]
r Hold down [ ] for 1 sec. to turn power OFF, then ON
again to exit set mode.
[ ]
User set mode is also available using a programmable key.
Please refer to p. 6 [User Set Mode] section for instructions
regarding using the key assigned for user set mode.
[User Set Mode] is allowed for the quick item selection.
Set “Enable” for the often used items with the CS-F3100D/
F5120D cloning software.