8
2
BASIC OPERATION
■ Call procedure
When your system employs tone signaling (excluding
CTCSS and DTCS), a call procedure may be necessary
prior to voice transmission. The tone signalling employed
may be a selective calling system which allows you to call
specific station(s) only and prevents unwanted stations from
contacting you.
q Select the desired TX code channel, 2/5-Tone code
according to your System Operator’s instructions.
• This may not be necessary depending on programming.
• Refer to pages 9–10 for selection.
w Push [Call] (assigned to one of the dealer programmable
keys).
e After transmitting, the remainder of your communication
can be carried out in the normal fashion.
Selective calling
Non-selective calling
■ Receiving and transmitting
Receiving:
q Hold down [
] for 1 second to turn ON the transceiver.
w Push [CH Up] or [CH Down] to select a channel, in
sequence.
e When receiving a call, rotate [VOL] to adjust the audio
output level to a comfortable listening level.
NOTE: Depending on the presetting, the transceiver
automatically transmits the microphone audio for the
specified period of time* when a matched RX code signal
is received.
• HM-148G or HM-152 hand microphone is required.
* Depending on the presetting. Ask your dealer for details.
Transmitting:
Wait for the channel to become clear to avoid interference.
q Take the microphone off hook.
• The ‘audible’ condition is selected.
• A priority channel may be selected automatically.
w Wait for the channel to become clear.
•
The channel is busy when BUSY indicator is displayed on the LCD.
e While holding down [PTT], speak into the microphone at
your normal voice level.
r Release [PTT] to return to receive.
IMPORTANT: To maximize the readability of your signal;
1. Pause briefly after pushing [PTT].
2. Hold the microphone 5 to 10 cm (2 to 4 inches) from
your mouth, then speak into the microphone at a normal
voice level.
To Next Page
Loading...
Need help?
General
