Icom IC-F9521T User Manual

5Push [Digital Button] (or [Digital Status]) again to
■ Short Messa
g
e
APCO P25 Mode Operation
enter the Individual ID selection mode.
• A pre-programmed ID name is displayed.
• When the ID name is not programmed, the ID
code is displayed.
g
Transmitting
The transceiver can send one of up to 10 different
pre-programmed Short Messages.
[Digital Button] or [Digital Message] key
assignment is necessary to transmit the Short
Message.
6Push [CH Up] or [CH Down], or rotate
[CH Up/Down] to select the desired ID (or name).
• Push and hold [Digital Button] (or [Digital Status])
for 1 sec to cancel and return to normal operation.
• The ID can be edited with the 10-keypad*.
(Depending on the pre-set value.)
* 10-key models only.
✔ For
Trunking mode operation:
The Short Message can be sent only to a dispatcher
in the Trunking mode.
1Push [Digital Button] to enter the digital call
type selection mode.
 ✔ Quick access

Push
[
Di
g
ital Messa
g
e
]
to directl
y
enter the
7Push [PTT] to transmit the Status Message to
the target station.
• The Transmit indicator lights red.
• “PLEASE WAIT” is displayed.
8Release [PTT].
• “ACK RECEIVED” is displayed after receiving an
acknowledgement from the target station, and
then the transceiver returns to normal operation

[g g]
y
 Short Message selection mode. In this case,
 skip steps 2 and 3. Go to step 4.
2Push [CH Up] or [CH Down], or rotate
[CH Up/Down] to select “SHORT MSG.”
then the transceiver returns to normal operation
.
• “NO ACKNOWLDG” is displayed when an
acknowledgement is not received and the
transceiver returns to normal operation.
Receiving
1When a Status Message is received;
• The Busy indicator lights green.
•
The ringer sounds
3Push [Digital Button] again to enter the Short
Message selection mode.
*A pre-programmed Short Message is displayed.
The ringer sounds
.
(Depending on the pre-set value.)
• The calling station ID name (or code) and the
Status Message blinks.
4Push [CH Up] or [CH Down], or rotate
[CH Up/Down] to select the desired Short
Message.
 While in the Trunking mode, the following steps

5
and
6
are not necessary Go to step
7
The received message
2An acknowledgement is automatically
transmitted.
• The Transmit indicator lights red.

5
and
6
are not necessary
.
Go to step
7
.
5Push [Digital Button] (or [Digital Message]) again
to enter the Individual ID selection mode.
• A pre-programmed ID name is displayed.
• When the ID name is not programmed,
the ID code is displayed.
The calling station ID name
51
3Push any key (except for [ ]) to stop the display
from blinking and return to normal operation.

Icom IC-F9521T Specifications

General

Brand	Icom
Model	IC-F9521T
Category	Transceiver
Language	English