5
SET MODE
13
5
D Auto power save function “PS”
The auto power save function reduces battery drain by de-
activating the receiver circuit for preset intervals.
• ON : The power save function is turned ON. The power save func-
tion will activate when no signal is received, and no operation
is performed for 5 sec.
• OFF: The power save function is turned OFF.
D Self check function “SC”
The self check function checks the transceiver conditions by
itself, and informs you in case a problem is found. Self check
automatically and quickly runs through its diagnostic steps
each time the radio is turned ON. Afterwards, the radio
switches to normal operation mode.
• Temperature : Outside of –35°C to +80°C; –31°F to +173°F
(approx.)
• Connected battery voltage
When error messages as shown below are displayed, see
troubleshooting for advice. (p. 24)
Push
Self check OFF (default)
Self check ON
Temperature error
Battery voltage error
Push
Power save ON
(default)
Power save OFF
To Next Page
Loading...
