3 - 1
SECTION 3 DISASSEMBLY INSTRUCTION
1. Removing the front panel
q Unscrew 8 screws A, as shown below, and then remove
the case in the direction of the arrow.
2. Removing the MAIN UNIT
q Unsolder the external speaker cable F (2 points), and
DC cable G (2 points), on the bottom side of the MAIN UNIT.
w Unsolder the antenna connector B (3 points).
e Remove the clip C.
r Unscrew 2 screws D, and 7 screws E, to remove the MAIN UNIT.
3. Removing the LOGIC UNIT
q Disconnect 2 cables I and K.
w Unsolder 2 points H.
e Unscrew 4 screws J, to remove the LOGIC UNIT.
A
A
A
RONT ANEL
CASE
E
C
E
B
D
G
F
speaker
MAIN UNIT
DC cable
I
J
K
H
LOGIC UNIT
To Next Page
Loading...
